i have installed a non vgt turbo on an 06 LLY (bosch ECM) and upon setting up a tune for this truck it is in limp mode at startup. with P0045, and P0405. 405 is the EGR and i have eliminated that issue. However P0045 is still active after one ignition cycle. I have set the P0045 to NOT REPORTED, however it is still causing an issue. I was not able to get the engine out of limp mode until i removed the boost control solenoid from the stock turbo and plugged into the harness. I know it is possible to eliminate this via software, and i have read some similar threads but those solutions arent working for me. I have the latest software and firmware.