Autocal Problems

[Blacky]

Blacky, I am a little confused on this:
"And try full-flashing the TCM instead of just cal-flashing. To do that, scroll down past the 5 "Prog n" entries until you get to the appropriate "Full n" entries (where n is a number between 1 and 5)."

I think you are talking about scrolling down in the autocal device, past the "prog" to the desired "full" entry?

Yes, that is what I meant.
Regards
Paul

[Blacky]

OK,

I think I got it squared away. I verified software versions and and downloaded a new tune from my tuner. Performed a full flash like Blacky mentioned. Seems to have loaded just fine, other than the longer time for the full flash.

Thank you so much for all your help.

Glad it worked out. The full flash takes longer due to writing more data to the controller: the calibrations and the operating system, instead of just the calibrations.

Regards
Paul