Problem logging SAE.MAP pid

[SW1911]

same problem here running cos 3 and im deadheadding at 105 very scary what do you do with that file joe? would you mind adding it in for me if and when you have time and maybe the stft fixer . i dont like messing with this file since the rr is running good , wont let me attach my ls1b file

[SW1911]

actually while out rr today i ran into a problem besides that , cruising at 55 or maybe 70 at 2000rpm when you let off the idle goes up to 3k until you hit the pedal which sounds like converter in and out but all tables are stock ??? very strange , i wasnt logging the trans so im not sure , maybe a filecheck since efi is new to me

[joecar]

same problem here running cos 3 and im deadheadding at 105 very scary what do you do with that file joe? would you mind adding it in for me if and when you have time and maybe the stft fixer . i dont like messing with this file since the rr is running good , wont let me attach my ls1b file

Hey Jim,

You merge the calc_pids.txt file into the existing calc_pids.txt file in the folder My Documents\EFILive\V7.5\User Configuration

post your existing calc_pids.txt file here and I'll merge it for you.

[joecar]

actually while out rr today i ran into a problem besides that , cruising at 55 or maybe 70 at 2000rpm when you let off the idle goes up to 3k until you hit the pedal which sounds like converter in and out but all tables are stock ??? very strange , i wasnt logging the trans so im not sure , maybe a filecheck since efi is new to me

Sounds like the throttle cracker/follower tables need to be looked at.

[SW1911]

thanks joe ,
is this the reason it wont roll over to the 115 table on its own ?

[SW1911]

i see one problem with the 105 deadhead c3003 is still at 105 max but the tutorial does not say what values to use , still havent found the weird 70mph 0 tps and the rise in idle

[joecar]

thanks joe ,
is this the reason it wont roll over to the 115 table on its own ?

Looks like you did not add the necessary A0009.RRR line:


A0009.RRR=CALC.xxxx

( whatever your BEN pid is )

[joecar]

Are you logging SAE.MAP or GM.MAP...?

[SW1911]

i logged all map pids that were supported just to be sure ,plx auto ve

did you see c3003 in my file ? thought the o/s would have taken care of that ??? just asking

[SW1911]

looks like my offset is incorrect for the cobalt map looking at my file the scaler is real close but im not sure what offset to use , been searching half the day and im getting different answers any help on this ?in kpa

thanks
jim