No wrong calc_pids.txt. You need to referencing this page: http://forum.efilive.com/showthread....VET-In-Reverse
Use the calc_pids.txt on that page.
No spreadsheet for smoothing the VE Table. You can use the smoothing techniques found on this page: http://forum.efilive.com/showthread....-Summary-Notes
Good luck.
Thank you Shawn. In the Calc you suggested above I will need to set up for my LC1 correct?
Yes. If Analog Wideband you will need to set up your calc_pids.txt file to include that.Originally Posted by 1bar
Yes, make sure your VET-in-reverse calc_pids.txt contains this:
Code:*CLC-00-110 factor 0.5 1.5 .4 "{GM.EQIVRATIO}*{CALC.AFR_LC11}/14.7"
Hello Joe,
Yes my new VET in REV calc has the above text in it.
Two questions.
1. In my scan tool I have a "WO2BEN factor" map that I plan to use to auto tune with. I made it the same as the SELBEN factor map in the Vet in REV page only using WO2BEN. Is this correct?
2. I cant set up the filters the VET in REV page tells me to. For some reason I can't pick OR to join parameters.
Thank you,
Glenn
1. Yes, correct, set the CLC for SELBEN to "{CALC.WO2BEN}" (edit only the stuff in between the quote marks).
2. Can you post a screenshot...
Hello Joe,
1. Ok in the Calc_pids I changed all of the SELBEN in quote marks over to WO2BEN with quote marks.
2.What is the easiest way to attach a screen shot. Its been over a year since I've done one.
Thank you,
Glenn
Glenn, try this link for information on hosting an image: http://forum.efilive.com/showthread.php?3064-Hosting-an-Image
Glenn, post the calc_pids.txt you are going to use.
Ok attached is my scanning software and the filters that I am not able to set up?
As well as my Calc_pids.txt.calc_pids.txtcalc_pids.txt
I think the Calc pids is correct. I cant set up the filters. Is it because I haven't done a log yet with the new Calc in REV set up?
I think I have my map set up correct as well.
What do you think?
Thank you,
Glenn
Posting Permissions
Reply With Quote