lost pids

[hecatti]

Hello everyone!

I have an issue after updating efi (version170).
In scantool where you choose pids , there is no longer pids for syl.balance rates, act. and des.rail press , inj. timing , dsp5 switch , nothing what you need to log LB7 or diesel
there is pids for fuel rail ,and difference between actual and desired fuel press but it´s not supported
I have been saved a pid list ,but when I open it nothing happened.
First I couldnt do anything before updating firmware which is now 2.07.14 and bootblock 2.07.02
now I´m totally lost , plesae help!!

sorry for the bad language

[joecar]

Hi hecatti welcome to the forum...


you may need to reinstall V7 and V8 manually.

[joecar]

Also see this: Pre-Release-Update-July-27-2011

[hecatti]

thank you and thank you!!!!!!
that fixed my problem

[hecatti]

hello again!
now I have problem with flashing, when I check status it says:
The Flashcan/Autocal firmware is not compatible with installed EfiLive software , please update the efilive software on your pc or laptop to the latest version and update the flashcan/autocal firmware that is
distributed with the efilive v8 software , the latest efilive v7.5 and v8 software may be downloaded from efilive.com

I tried several times but still no luck , is it possible continue and make the flash even if status is not ok?

thank you already!!

[joecar]

What V7 and V8 build versions are you at (post screenshots)...?

What V2 bootblock and firmware versions are you at (use EFILive Explorer; post screenshots)...?


The software/firmware versions must be compatible otherwise flashing will fail and the PCM/ECM will be bricked.

[hecatti]

well, I don´t know how to post screenshot, but my V7 is version 173 and V8 162
V2 bootblock 2.07.02 and firmware is 2.07.14

[joecar]

Ok, use EFILive Exporer (goto Firmware tab) and do this (in this order):
- update V2 bootblock to 2.07.03 (checkmark Bootblock checkbox),
- update V2 firmware to 2.07.16 (un-checmark Bootblock checkbox).



Screenshots: see posts #2 and #3 here: Hosting-an-Image

[hecatti]

thank you for advice , I´l do that next and try again

[hecatti]

hello
Finally I got everything up to date , it seems that new version was released again since yesterday and I was little lost (again) , but now everything looks good.
thanks Joecar!