New tables

[FUBAR]

I have to say, my tune fuels A LOT harder after modding the new tables. How much? I need to inspect my logs more closely to give definitive numbers. Thumbs up though!

[1slo_CR]

Can someone please explain to me the new tables in the pre-release? E2536 Fuel Limiter, Table Selection 2 and E2567 Equivalence Ratio Limit (Especially this one.) Are one these the tables the one we have been looking for regarding the 2800RPM full fuel limiter? Or Torque Limiter?

??? Not to sure here either?

Looking for some input about the "Fuel Limiter, Boost" too...?

[LReiff]

I finally got some dyno time, power still drops above 2800rpm.

[Dmaxink]

LReiff..have you changed the axis points in your tunes?

[97singlecab]

The new tables work great for me. Here is the difference is dyno sheets. The truck carried 140mm3 all the way to 3800 on this run which is where I let out.

[MQ105]

That's good. Can we see the data logs that show full commanded fuel throughout the run? Thanks.

[FUBAR]

I've got no problem carrying 140mm3 up to those rpm's, it's the pulsewidth that's still the demon.

[MQ105]

I'd like to see the logs, and know what you changed to allow it.

Thanks

[FUBAR]

Axis Tables. Think of it like this, the set guidelines in some of the tables mis-represent what our engine is really capable of.

[FUBAR]

Here, it's 150mm3ish at 2800RPM and tapers down to 130mm3 at 3600RPM. 3200rpm shown here in the log is at 140mm3.