A lot of PID's missing
I upgraded to the new software 7.5.7 Build 170. I am attempting to log misfires, but for some reason the PID's are gone. It also seems as if the PID list has been cut in half. None of the GM PID's are there anymore (IE GM.KR). Even the 'Misfire' selection in the system dropdown (shown in pic) is gone too. Not sure what I'm doing wrong. I unselected the "Supported" checkbox. This software update has been hell for me.
Thanks for the help.
Josh
Last edited by joshp14; July 28th, 2011 at 01:22 PM.
Hi Josh,
There's a new software build, do a manual install from Pre-Release-Update-July-27-2011
Install both V7 and V8 from there, and then also install V2 bootblock 2.07.03 and firmware 2.07.16.
i already have v8 installed. whats the point of having v8 installed? do i uninstall both programs then install manually? i literally updated everything last week to the newest stuff and thats when i started having problems with the PID selections. I cant even do any autove because all of the PID's arent there to select. Will this update FIX my problem?
Do you want your pids to reappear...?uninstall and then install V7 manually (i.e. do not do the update).
Why do you need V8...? So you can install the newer firmware, this makes your V2 firmware version compatible with your V7 build version.
Do you have these installed:
- V7 build 173
- V8 build 162
- V2 bootblock 2.07.03
- V2 firmware 2.07.16
Why else do you want V8...? So you can do BBL and BBF (i.e. avoids the need to have laptop in car).
ok uninstalled V7 and V8. Reinstalled with the links provided above and then updated boot block and firmware.
I still have the same problem. Apparently I'm doing something wrong....
Hey Joecar, can cummins bbl and bbfOriginally Posted by joecar
Do you want your pids to reappear...?
Why do you need V8...? So you can install the newer firmware, this makes your V2 firmware version compatible with your V7 build version.
Do you have these installed:
- V7 build 173
- V8 build 162
- V2 bootblock 2.07.03
- V2 firmware 2.07.16
Why else do you want V8...? So you can do BBL and BBF (i.e. avoids the need to have laptop in car).
Once installed, is there something else I have to do to get these PID's to show up? I tried the 'validate PID's' in the info drop down but no luck.
Not that I know yet.
Do this:
- connect scantool to vehicle,
- File->Connect,
- File->Enter VIN,
- File->Select Controller,
- Info->Validate PIDs,
does it see pids now...?
What year/model/vehicle...?
Last edited by joecar; July 29th, 2011 at 03:33 AM.
Thanks
Posting Permissions
Reply With Quote