Results 1 to 4 of 4

Thread: LTFT desired values for idle, light throttle, WOT

  1. #1
    Junior Member
    Join Date
    Nov 2003
    Posts
    35

    Default LTFT desired values for idle, light throttle, WOT

    Hello,

    I am not sure what the desirable long term fuel trim values are
    for (manual transmission, 2000 LS1 engine, F-body):

    1. car fully warmed up, car at idle for several minutes
    (when near stock my car would gradually go to +22...24% from whatever value it was when driving

    2. car fully warmed up, light load, light throttle, say 4th gear going 45 mph

    3. car fully warmed up, WOT (or in PE mode)

    Maybe there is a reference table where the LTFTs are supposed to be versus the fuel cell numbers?

    Thanks,

    Gert

  2. #2
    Senior Member WicketMike's Avatar
    Join Date
    Nov 2003
    Posts
    112

    Default

    the LTFTs are suppose to be -5 to 0 everywhere and 0 at WOT.

    if you where getting +22, then you have a problem. Maybe your MAF is dirty

    98' White TA A4 TSP 231/237 PP Stage II 59cc heads
    401rwhp (unlocked) 1.594 60'-11.60 e.t.-116.98 mph
    ---------
    98' Sport Gold Metallic TA M6 - 13.39 e.t. Bone Stock
    My Trans Ams
    ---------
    2006 Chevy Monte Carlo SS 5.3L LS4 (wifes car) stock (for now)

  3. #3
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    ...+22...24%...
    Possible causes:
    a. air leak up stream of front O2 sensor;
    b. air leak down stream of MAF sensor;
    c. IFR, VE, MAF tables don't match your mods.

  4. #4
    Junior Member
    Join Date
    Aug 2005
    Posts
    29

    Default

    Mine was at 25% and I found a crack in my intake by the MAP sensor.
    Dale

    78 Datsun 280Z W/LS1/T56

    TR230, Absolute Speed stage II 5.3 heads, Fast 90mm setup, JTR 1 3/4 headers.


Similar Threads

  1. 2010 throttle position values ??
    By 2010 Bumblebee in forum E37, E38 & E67 PFI ECM's
    Replies: 4
    Last Post: May 7th, 2010, 02:19 AM
  2. Good source for typical LTFT values?
    By PewterC5 in forum General
    Replies: 3
    Last Post: August 2nd, 2006, 05:27 AM
  3. Desired Idle Speed and Idle Airflow
    By Bowtieman in forum General (Petrol, Gas, Ethanol)
    Replies: 1
    Last Post: March 20th, 2006, 10:07 AM
  4. LTFT desired values for idle, light throttle, WOT
    By 2000ssnb in forum General (Diesel)
    Replies: 2
    Last Post: January 17th, 2006, 03:29 AM
  5. 2001-2002 F-body LTFT cell RPM boundary values
    By joecar in forum General (Petrol, Gas, Ethanol)
    Replies: 5
    Last Post: February 8th, 2005, 07:54 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •