I tried the CalcVET and when I copied over to the Main VE table the data doesn't look right to me. Could someone help me with what I did wrong. Thank you.
Here is a copy of my log and tune file:
I tried the CalcVET and when I copied over to the Main VE table the data doesn't look right to me. Could someone help me with what I did wrong. Thank you.
Here is a copy of my log and tune file:
2006 GMC CCSB 1500HD 4X4 - Radix 3.2 pulley, Pacesetter Long Tubes, Magnaflow exhaust
Post pics of your map and the VE table after you past-with-labels.
Ok, this is the problem: your tunetool is displaying B0101 VE table in units [%], whereas your scantool map is displaying in units [g*K/kPa].
So you have to be sure to use the same units in tunetool and scantool;
you can do this by doing one (and only one) of these:
- in the tunetool, go Edit->Properties and set the VE units to g*K/kPa,
- in the scantool, for the map data use CALC.VET.% (i.e. the one with % units);
when the units match, your scantool map data would be much closer to the VE table cell values.
BTW: remember to:
- eliminate map cells that have low count (empty).
- apply the transient filter.
Under edit map properties > empty (tab) I checked hide empty cells and set the low count to 10. Is there something else I should change?
2006 GMC CCSB 1500HD 4X4 - Radix 3.2 pulley, Pacesetter Long Tubes, Magnaflow exhaust