Bricked 2 E37 ECMs?

[engimuneer]

I've had this problem repeat itself twice now and not quite positive what the issue is.

Taking a standard E37 ECM from MY09, I performed a few cal flashes successfully. When I load up Scan & Tune V8 and perform a full-flash I get the following errors.

$06FF = $checksumfailure

Any restarting of the laptop & Flashscan V2 has only led to additional errors when trying to full flash again.

$0534 = invalid serial number immediately after attempting

if it will proceed to the next step, it will erase and then send a 'no data recieved' error

$0540 = OS mismatch between 12630187 & 0.


Anyone point out why this failed twice? One ECM was out of an 09 HHR [L4] & the other out of an 09 Silverado [V6]

Is there anyone to unbrick these units? Hate to lose the licenses for them.

[GMPX]

Did you get any warning about incompatible OS's when you full flashed?

[engimuneer]

The only time the Incompatible Operating System warning came up was on the 5th attempt to recover.

[GMPX]

Would you mind sending the file you've used to support@efilive.com plus the original 'as read' files from the 09 HHR [L4] & 09 Silverado [V6].
We have a lot of checks in the software to ensure this corruption can't happen, so I am surprised it's caught you out twice.