Results 1 to 3 of 3

Thread: Efilive communication issue with dyno (powerdyne) software

  1. #1
    Lifetime Member Dmaxink's Avatar
    Join Date
    Nov 2009
    Posts
    1,176

    Default Efilive communication issue with dyno (powerdyne) software

    Has anyone ever had a issue with the scantool not connecting when the dyno is connected? This also effects the lockup controls on the dyno. The scantool will not connect or log when the powerdyne software is engaged...any takers?
    -Kory

    I'm out of ideas? Nah trick... When in doubt, 0xFFFF it out!

    http://www.PPEI.com/

  2. #2
    Lifetime Member GMPX's Avatar
    Join Date
    Apr 2003
    Posts
    13,148

    Default

    You can't run two scantools on the vehicle at once.
    Or, is the Powerdyne software running via V2?

    Cheers,
    Ross
    I no longer monitor the forum, please either post your question or create a support ticket.

  3. #3
    Lifetime Member dansdieselp's Avatar
    Join Date
    Apr 2009
    Posts
    606

    Default

    Photo tach is the only way to go if you want to log while on the rollers. We have a spare five speed Allison TCM tuned for fourth gear only with TC lockup in TH for dyno tuning. The six speeds usually hold in manual mode.
    Dan's Diesel Performance
    www.dansdieselperformance.com

Similar Threads

  1. Dyno software integration
    By samgm2 in forum FlashScan V2
    Replies: 17
    Last Post: September 3rd, 2011, 09:51 PM
  2. Looking for help 03 6.0 powerdyne supercharger
    By oldblue_6 in forum Forced Induction and Nitrous Oxide (N20)
    Replies: 2
    Last Post: September 17th, 2010, 07:19 AM
  3. Software issue
    By Dallas S in forum FlashScan V2
    Replies: 6
    Last Post: June 11th, 2009, 01:39 PM
  4. V7 software issue scanning misfires
    By BigTex in forum General
    Replies: 6
    Last Post: March 14th, 2005, 09:29 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •