Hehe yeah I guess the data isn't much good if its all zero due to the engine stalling out ;P
I'll try to get that log made tomorrow after work and emailed. Thanks again for taking a look.
No, it's all good, now go have some fun :-)Originally Posted by turboberserker
Just remember to try to keep the PID count under 24 channels.
Cheers,
Ross
I no longer monitor the forum, please either post your question or create a support ticket.
Ross,
Is each PID considered a channel?
Howard
www.redline-motorsports.net
1-954-703-5560
2006 ZO6 895/866 with APS TT
2010 SSRS Camaro HTR-900TT (798/801)
2011 HTR-850R Camaro
2012 ZL1 Auto (10.33@135 MPH) Video Here!
Some take 1, some take 2, some take 0 !.
If you look at the colum in the PID selection called 'Channels' that will tell you how many channels each PID takes.
Also, down the bottom of the screen will be some text that says "Selected channels 24 of 96 maximum" , as you add / remove PID's that shows you the amount of channels taken up.
Cheers,
Ross
I no longer monitor the forum, please either post your question or create a support ticket.
Erik, I just hit the same wall. Did a little logging and at low boost KPA stopped at 105... I'm only using 21 channels, did you change anything else to get it to work?
I just changed my BEN table to match the Main VE and created a second (Efi map) for the BEN under boosted VE. I orignally combine both the main and boosted ve KPA values onto a single (efi map) because it seemed to make sense.
Also does anyone know why PID GM.BOOST comes up "is not a valid PID"
Damnations,,,,
Without looking, I would guess its a Duramax Turbo Diesel PID - not available on gas engines as gas engines (LS1/LS6) did not come with factory turbos.Originally Posted by MN C5
You should use SAE.MAP to see the MAP on gas engines using our 2-3 bar custom OS.
To see the actual boost you could create a calculated PID that uses the expression: {SAE.MAP} - {GM.BARO}
Regards
Paul
Before asking for help, please read this.
Looking up fast stream mode right now.... Yes its set to Stream-Fast...Originally Posted by turboberserker
I'm going to run around the block after changing my boost VE values to 5's and see if it is referencing the Boost VE table..
Be back in 10