Results 1 to 7 of 7

Thread: Innovate MTX-L to Flashscan V2 Serial Connection

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    New Member
    Join Date
    Nov 2011
    Posts
    2

    Default Innovate MTX-L to Flashscan V2 Serial Connection

    I'm trying to figure out why I keep getting WO2 Not Found on the V2 after setting up my MTX-L via serial.

    From the MTX-L Gauge I have used the supplied serial cable from the Serial OUT on the Gauge to then a DB9 female to female converter then using the supplied flashscan v2 cable I plug it into the RS232 port on the V2.

    Has anyone used one of these gauges with a V2 before? Apparently they're exactly the same as the LM2. Do I need to make any alterations to the cable itself?

    Hope someone knows

    Cheers....

    :edit:
    Ended up sorting it out by swapping pin 2 and pin 3 on the rs232 side
    Last edited by foakley; March 8th, 2012 at 12:27 AM.

Similar Threads

  1. innovate MTX wideband
    By maudyZ28 in forum Gen III V8 Specific
    Replies: 30
    Last Post: June 21st, 2011, 01:02 PM
  2. LC-1 serial connection question
    By JUSTASBC in forum General
    Replies: 2
    Last Post: March 11th, 2011, 10:41 AM
  3. LC-1 serial connection
    By nathans1987 in forum Tutorials
    Replies: 11
    Last Post: May 26th, 2009, 10:08 AM
  4. FlashScan V2 Wiring w/Innovate LC-1
    By -X- in forum FlashScan V2
    Replies: 8
    Last Post: November 19th, 2007, 04:15 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •