Hi there i have a set of 60lb vdo siemens injectors withe the following specs
•Coil Resistance: 12.5 Ohms / High Impedance / High-Z (No ECM driver modifications required)
•Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 60 lb/hr = 630 cc/min = 453 g/min
•Static Flow Rate @ 87PSI ( 600kPa ) w/Gas: 85.7 lb/hr = 900 cc/min = 648 g/min
•Gain: 0.11ms/mg
•Offset: 0.055ms
•Turn on time @ 14VDC: 1.14ms
•Turn off time: 0.85ms @ 600KPa
what do i need to do to change the injector specs to suit for an ls1b ecu?
The only thing i can see so far that correlates to the parameter chart is the turn off time so i have changed that from 0.7969 to 0.85 but am unsure what to do from here, any help would be great cheers.