Hi,
Does anybody know how you could go about making curve charts using the data from scantool?
Say, if I wanted to have a curve charts showing engine torque versus RPM. how would i get the logged data so I could make a chart?
Cheers,
laychut
Hi,
Does anybody know how you could go about making curve charts using the data from scantool?
Say, if I wanted to have a curve charts showing engine torque versus RPM. how would i get the logged data so I could make a chart?
Cheers,
laychut
Going places no one else dares to Go!
60 Series Landcruiser, GenIII LS1 5.7, 4L60E Trans, 4" Stainless Snorkel
4" Lift, 35 x 12.5 BF Goodrich Mud Terrains
You can log GM.TRQENG and SAE.RPM...
GM.TRQENG is the PCM's calculation of engine torque based on MAF/VE and the spark tables... it's an estimation and it may or may not be correct.