Any idea what this is? I tried to log some data and this kept coming up. Thanks!
Any idea what this is? I tried to log some data and this kept coming up. Thanks!
updated to 2.07.32. Should this fix my issue?
Are both the bootblock and firmware updated...?
After updating the firmware, did you program the BBx config...?
On AutoCal immediately after starting a log, if it shows two lines:
Line 1: Controller Type
Line 2: PID Name
it means that PID is not supported.
Try deselecting the PID, reprogramming AutoCal with the new PID selection and retry logging.
Regards
Paul
Before asking for help, please read this.
What operating system is your E38 running? The pids ending in _M are supported specific to each operating system.
I'll check if it should be supported for you OS or not.
Regards
Paul
Before asking for help, please read this.