truck isnt going to full mm command or timing?????

[DieselMafialb7]

Ok well any other ideas on the mm being limited and timing? Will bumping up ttva help mid and full throttle shifts?

[LReiff]

Make small changes to the limiting tables and note the results. You'll soon figure out what is holding fuel back.

[DieselMafialb7]

Ill give the limiter tables a whirl

[kaiserbailey]

got a 06 5.9 wont go past 120mm or past 6-8* timing i cant figure it out ? any hints tables i may have missed? scan tool showed it was stopping anywere from 115-123mm truck has a built 48re and exhaust any help is appreciated

That's probably all the timing your going to see on a stock tune, or have you already changed the timing tables?

[DieselMafialb7]

That's probably all the timing your going to see on a stock tune, or have you already changed the timing tables?

ITS not a stock tune.... calling for 24*

[DieselMafialb7]

maxed out limiters and still holding timing back to 7*but fueling went up to 135 this time so made improvement there

[kaiserbailey]

ITS not a stock tune.... calling for 24*

Did you change all 5 timing tables or just the base table?

[DieselMafialb7]

All 5 are the exact same

what about table D6267?

[kaiserbailey]

It might be easier to diagnose if you post the tune file.

[DieselMafialb7]

how do i do that and it has to be something stupid i know it