Originally Posted by
drthv8r
Hello all. I back probed the red wire and there's no voltage there, so much for believing in the V2 and the PIDs for reading the voltage correctly for me. I guess that's pay back for being lazy and not double checking using a meter. I made sure the red wire went into the correct pin hole and also made sure the locking tab on the red wire was pointed towards the center line of the connector. I didn't force it when it went in originally and it went in pretty far I've just been using things to try to push it down into the connector more since I couldn't get anything to work thinking maybe it just wasn't seated down far enough and making a loose contact. I'll try to get the pin back out without pulling the pin off the wire and see what's going on with it.
I guess I'm down to the locking pin not being inserted the correct way, the ECM has a dead spot where the pin connects to (that would be my luck) or the pin on the end of the wire isn't making contact with the red wire. Monte made an excellent detailed video and I thank him for that. I guess the one good thing with all this is I can now remove the ECM connectors blindfolded...lol. Thanks once again for all the feedback.