Your TP filter parameter - TP not equal to 21% has me concerned - the filter will take out all other TP % cell hits.
I'd just go with the filter setting advised on Pg 13 of the AutoVE Tutorial (found under Help - tutorial - AutoVE in the scan tool program) in the first instance.
cheers
HSV Senator 300 - the Classy C4B...
C4B - ETP215s 62cc, Comp 215/223 .601/.609 @111+3, Manley 8.050" 5/16" P/R, Morel Link-bar lifters, Powerbond 25% UDP, 36lb injectors, SLP pump, Rollmaster chain, OTRCAI, T-56 - RipShift, HydraTrak 3.91:1, DiFilippo 1.75" 4-1s, twin 3" st/st cat-back, 3" metal substrate hi-flow cats. AP-Racing 6/4-pots. EFIlive COS3 SD tune.
308rwkW(413rwhp)
Jeff,
That filter is incorrect... (somehow your filter got crossed)
it should read like this:
Filter control: Include data frames
{SAE.TP} is changing less than 5% per 100ms AND
{GM.FTC.cell} is not equal to 21 AND
{SAE.ECT.F} is greater than 176°F AND
{SAE.RPM} is greater than 500 RPM AND
{SAE.TP} is greater than or equal to 1%
Jeff / Joe, I posted an example screenshot of an AutoVE map result and a basic filter setting in Jeff's other thread. Hope it helps.
cheers
HSV Senator 300 - the Classy C4B...
C4B - ETP215s 62cc, Comp 215/223 .601/.609 @111+3, Manley 8.050" 5/16" P/R, Morel Link-bar lifters, Powerbond 25% UDP, 36lb injectors, SLP pump, Rollmaster chain, OTRCAI, T-56 - RipShift, HydraTrak 3.91:1, DiFilippo 1.75" 4-1s, twin 3" st/st cat-back, 3" metal substrate hi-flow cats. AP-Racing 6/4-pots. EFIlive COS3 SD tune.
308rwkW(413rwhp)
Joe! In the Data Filter, I can not add {GM.FTC.cell} it say it is not valid .And when I go to the pid list,It will not let me add it to my pid list! That is the (Fuel trim cell number),and do I need to apply that to my filter???? If so how do I do it. Cheers
That means you did not log GM.FTC... so then you can leave FTC out of the filter.
Hi Joe! My B3618 in open loop I set them at 1.00 and B3605 I set them the same as the AutoVE Tutorial,My question is on the {Things to check}Did you want me to set thoses two table to AFR not EQR units.Thanks jeff
Regardless of the AutoVE tutorial, set B3618 to your target PE/WOT EQR (1.16 for NA), and set the last 2 columns in B3605 to the same value
( this does not cause any problems in AutoVE because you will see those values in the pid GM.EQIVRATIO )
( last few columns in B3605 in the tutorial is too lean for my liking; problem with B3618 set to 1.00 is that people forget to set it back to rich )
( note: if your BARO is less than 100 kPa, then set all the columns in B3605 from (BARO - 5) kPa to 100 kPa to the same value as B3618 )
I would prefer to use EQR units everywhere.