Hi Guys I have started auto VE tuning, Please take a look to see if I am on the wright track,I am using a Fast WB,and I have done everthing the tutorial say's to do,.
Log_jeff keyuk_AutoVE_Tune8.efi
Hi Guys I have started auto VE tuning, Please take a look to see if I am on the wright track,I am using a Fast WB,and I have done everthing the tutorial say's to do,.
Log_jeff keyuk_AutoVE_Tune8.efi
Your throttle is not sufficiently steady, the transient filter "Base Efficiency Numerator" is throwing out all the data.
Also, you need to set your LM1 to 1/6 filtering to smooth out the measured AFR;
the measured AFR is tending to be rich.
Hi Joe! Thanks for the answer back, I will be more steady with the throttle,Question on the Base Efficiency numerator,In on the map properties,I click on to (Base Efficiency Num.1-LM (factor)-not currently selected). I take it that is wrong,Which one is the one I should of click on to!And in the Data filter 5.00% is to high, As you can tell, I new to this. Thanks again for any help.Cheers Jeff.
Hi Jeff,
No worries... post a screenshot of the filter you see...
Hi Joe Not sure how to do a screen shot,but this is what I am looking at in the "Data Filter"
NAME ( TPS MOVES TOO FAST OR LOW COOLANT TEMP)
FILTER CONTROL: (Exclude date Frames) and I think that should be [U](Include date Frame )
and in the FILTER TYPE is ( Changeing mor than 5:00% per 100ms.)
than I have inthe Filter (Sae.ECT)is changing more than 66.80degrees C.per 100ms.
Hope this is ok what I just posted to you. I will try and do that screen shot.Thanks again jeffkeyuk@live.ca
Screenshot, see post #2 or #10 here: Hosting-an-Image
Hi Joe, No luck trying to screen shot my filter data. The printscreen tab seem to not work on my key board???? I have the image editor greenshot,Question Can't you just click on Log file up top to see the filter data Log_jeff keyuk_autoVEtune8 on the first page and see it there.
When Greenshot is installed it intercepts the PrtScrn key-press and captures the screen (you have to mark a rectangle on the screen using the cross-hairs).
Your filter may not look like mine... (the filter is not stored in the log file).