Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Open Loop Fuel Economy Results

  1. #11
    Lifetime Member BowlingSS's Avatar
    Join Date
    Nov 2003
    Posts
    607

    Default

    Quote Originally Posted by TAQuickness
    With the V3 OS, I've managed to get my mpg up from and average of 13 mpg to 19 mpg. Timing tables are still pretty agressive so I know there's room for improvement still.
    I am still running around 13 around town. A lot of stop and race.

    Bill
    2011 Camaro 2SS/RS L99 RJT
    CAI, Inc. Cold Air Induction;ADM Scoop
    Rx Catch Can;Rx Breather;Roto-Fab Washer Container
    VMax Ported RJT Throttle Body
    XSPower Headers and XSPower 3" Exhaust System
    Elite Engineering Tunnel Brace,
    Gorilla Wheel Lock System;
    Tinted Windows 35%;EFILive Tune

  2. #12
    Lifetime Member oztracktuning's Avatar
    Join Date
    Nov 2005
    Posts
    596

    Default

    Mine has averaged about 19.5mpg over the past few months.

  3. #13
    Lifetime Member oztracktuning's Avatar
    Join Date
    Nov 2005
    Posts
    596

    Default

    Just checked mpg at the pump again. It was 15.1L/100km the last tank and the last tank had quite a bit of idle tuning in it. 15.1 is 18.7MPG .
    Also most of the tank i didnt have DFCO enabled.

    Now its quite aggressively enabled - so it will be interesting to see what it does soon.
    Oztrack
    EFILive Tuning Consultant

    Worldwide Remote Tuning Service

    2006 NSW Super Street Drag Racing Champion

    www.oztrack.com.au


Page 2 of 2 FirstFirst 12

Similar Threads

  1. can you utilize fuel trims and stay open loop?
    By Kurtomac in forum Gen III V8 Specific
    Replies: 19
    Last Post: March 16th, 2009, 12:01 PM
  2. Commanded Fuel when in open loop and PE modifier based on RPM
    By Thumper in forum Gen III V8 Specific
    Replies: 37
    Last Post: September 6th, 2008, 09:47 PM
  3. Semi-Open Loop: what's the fuel economy like?
    By SSbaby in forum General (Petrol, Gas, Ethanol)
    Replies: 7
    Last Post: October 20th, 2007, 12:28 PM
  4. {B4206} Use O2 With Open Loop Commanded Fuel Table
    By joecar in forum General (Petrol, Gas, Ethanol)
    Replies: 16
    Last Post: September 7th, 2007, 03:56 AM
  5. OPEN-LOOP based fuel control in Cos 3...question.
    By WiseGuyZ06 in forum Custom Operating Systems
    Replies: 12
    Last Post: July 14th, 2007, 07:26 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •