Can't get this thing to read voltage for the life of me. Am I doing something wrong or does it just not work?
Can't get this thing to read voltage for the life of me. Am I doing something wrong or does it just not work?
make sure you have the right ECM selected and validate the pids
2008 Chevrolet 3500HD DRW LTZ
285/75/17 Nitto Dura Grapplers, 4.56 gears, Front and rear ARB lockers, Efi Live tuning by me, Raptor 160 LP, Cognito 4-6 NTB Lift, 4" Exhaust, Built Trans by Mike L.
Sold - 2004 LB7 Duramax, EFI Live with DSP5 Tune
stage 4 SC transmission, 265/70/16 tires
Also you do have a DSP5 OS in it correct? If you have a DSP2 it will not show up. And I don't know why, but for LB7's I have found I have to validate the PIDS everytime regardless.
1995 GMC 2500 SUBURBAN powered by 01 DURAMAX/ALLISON, little of this, a little of that,
DIAMONDEYE 4" exhaust, CORSA muffler, AFE stage 1 dry filter, custom tuning by me, KENNEDY single pump and pump rub kit.
I ended up figuring it out. For whatever reason, the V2 wouldn't monitor just the DSP voltage. After some googling, I tried selecting multiple PIDs and it worked like a charm. Everything was functional tune and OS wise, I believe that the pin connection at the PCM was poor. The voltage seemed glitchy. Swapped out DSPs and it worked perfectly. Also seemed like I had to re-boot the V2 to get it to connect to the scan tool properly.