Originally Posted by
joecar
Look at the AutoVE tutorial (each step describes what it does)...
in particular, look at how it disables trimming (B3801, B4206) and closed loop (B4205).
You should also re-enable DFCO B3313 and COTP B0701.
You should set B3605 and B5914 back to stock.
Important:
- set PE B3618 to suitably rich for load/WOT... (I hope you did not tune with this set to EQR 1.00).
I DID..
- set PE Enable B3616 to enable properly (something like 65 below 3400 and 35 above 3400).
- I hope you had B4206 disbaled during tuning.