Hi Jeff, use this one (it should already be in the Name pulldown):
(note that it says "Include data frames")
thank joe! I thought so! Just what do make sure.That's the same filter I used for Auto VE.Table So you use this filter for all the calc VE Tables.
Yes, that's correct, filtering is the same for any of the tuning procedures.
Hey Joe! Couple of question! In on making a B0101 Map it say on the [Data]Tap to select the Calc VE from the Parameter drop down list,
There are 4- to pick from
1 Calculated VE,ben correct(%)
2 Calculated VE,Ben correct (g*K/kpa)
3-calcuated VE,not corect(%)
4-calculated VE,not correct(g*K/kpa)
I had select # 2 Then on the "Filter". On the last line you said to apply (GM.FTC cell) is not equel to 21.00 cell.) This is not in on my Parameter Drop down list !
Do I really need it. Thanks Jeff!
Oh Yea! After doing all that, I when't out and did a logging, Everything looked ok! On the B0101 map ,click on the average button ,the cell count when't BLANK ??
Yes, select CALC.VET ("calculated VE, corrected") g*K/kPa
( on the Data/Row/Col tabs, checkmark Show Names to see the pid names ).
If you did not log GM.FTC, you can delete that line from the filter (since the line above it ("TP > 1%") covers this, so you don't really need it)
Must be something Ive done wrong!
URL=http://imageshack.us/photo/my-images/24/jeffsveb0101map.png/][/URL]
Thanks Joe !
What did you set the Empty Cell count to...?
Ok, now click on the average, and click on the apply filter button.