03 dsp5 problem

[Dirty dmax 06]

i made a dsp5 tune for a 03 lb7 recently an am having trouble with the switch the voltages change as they should when i utrn the knob but when i logged it to check voltages and tune position the volts were fine like i said but it came up with non dsp on numbers one and two and then 3 was dsp1 and 4 was dsp2 then 5 jumps back and fourth between dsp3 and dsp4 i just cant get it figured out ive changed the voltages to what they logged out to an it did nothing

[THEFERMANATOR]

I had one do this to me before. I lowered teh voltage down .5 volts for each and it worked afterwards.

[Dirty dmax 06]

I just tried it and it helped with #5 on the switch it stopped changing but it was still non dsp, non dsp,dsp1,dsp2,dsp3

[dansdieselp]

Are your dsp5 wires spliced by chance? If they are and butt connectors were used cut them out and solder the connections.

[THEFERMANATOR]

What values do you have in for the switch voltages now?

[Dirty dmax 06]

ok i played with the voltages an i took dsp three all the way to 2.8 volts and it still interfiered with dsp four at .5 volts now my voltages are at
non dsp-5v
dsp one-4.00v
dsp two-3.40v
dsp three-2.30v
dsp four-.50v

and when on dsp4 it still slightly changes between dsp3 and dsp4 but is on dsp4 the majority of the time