I've had scaning working, but now when I click the yellow dot it comes up with ERR_RESPONSE/5
Response $11 Mode Not Supported
What have I stuffed up
I've had scaning working, but now when I click the yellow dot it comes up with ERR_RESPONSE/5
Response $11 Mode Not Supported
What have I stuffed up
1) Launch EFILive’s Scan tool.EFILive Scan Tool For Duramax DieselQuick Start Guide
2) Enter VIN? >Yes
3) Platform> Light Truck
4) Engine> 6.6
5) Go to “Edit”>Properties>select the “Logging” tab.
6) Changed the “Scan Mode” to “Dynamic.”
7) Select “OK.”
8) Close the Scan Tool software.
9) Re-open or launch the Scan Tool software.
10) Go to “File”>Open>Open PID selection file>Duramax Imperial.
11) Select the green dot in the upper left hand corner to “Connect.”
12) Go to “Info”>Validate PIDS
13) At this point you can view the PIDS that are selected to record by using the F8 key. Double click any PID to select it for recording or double click again to deselect and turn grey to not use it for recording.
14) Select F9 for the Data page.
15) Select the Yellow dot at the bottom of the screen to monitor live data. Select the Blue square to stop monitoring data.
16) Select the Red dot at the bottom of the screen to record data. Select the blue square to stop recording and save the recorded data to a file.
This should get you started. There is more in depth instruction in the Tutorials that are provided under the “Help” Menu.
www.socaldiesel.com
EFILive-DSP5......Switch your Attitude!
EFILive-CSP5......The Smart Way To Switch Your Cummins Tunes!
EFILive-DSP4......Switch Your Colorado and Canyon Too!
THanks for reply, have been following those instructions you posted on DP on02-08-06. Just tried again still coming up with error.
Possibly something to do with me uninstalling + reinstalling V7.3.1
Try changing to a different logging speed. If that fails try all the different USB ports on you computer.
www.socaldiesel.com
EFILive-DSP5......Switch your Attitude!
EFILive-CSP5......The Smart Way To Switch Your Cummins Tunes!
EFILive-DSP4......Switch Your Colorado and Canyon Too!
Help is not too far away Ed
Cheers,
Ross
I no longer monitor the forum, please either post your question or create a support ticket.
All go, with Paul's help, just had too many PIDs selected.
36 is max in Dynamic mode - it shows the total at the bottom of the page.
For example, checking injector balance rates is 8 x 2 PIDs each = 16, so you need to unselect others so you are not over 36.