bad BBx log file

[restless@westnet.com.au]

bugger i just drove 40k and did a log this is how it came out is it corrupt ? or have i got some setting wrong ,or was the log to long about 30min

data # are way out to like rpm 68,000
water temp 256 c. ect
how do i post a log file ?


I JUST went and did another 5min one and its the same whats wrong ? i have re configured it as well
all the old log files play back no problem ?
thanks

[joecar]

See these:

What-s-wrong-with-BBL-to-cause-this
Why-does-this-happen-alot-log-reading-prob
Beta-Releases-and-Log-Files-Full-Of-Notes
Strange-log-file-problem


Attachment 11390

[restless@westnet.com.au]

OK i have borrowed a friends v2 and laptop

to see if the log works on another PC (no its still corrupt )

i transferred the log to his v2 using my PC still corrupt

i then removed the TCM pids i put in yesterday before i did the log and did a small log just idling in the shed IT WORKS fine so it must be something to do with the TCM T43 PIDS i loaded ? (dont know witch one )
any reason for this ? if you give me an email adress i can forward the log or tell me how to post it here

thanks

[joecar]

Remove all the TCM pids... and then add them back one at a time until you find the one(s) that don't play.

[joecar]

For posting log/tune files, see post #22 here: Help-with-CalcVE-Tuning-Filter

[restless@westnet.com.au]

Remove all the TCM pids... and then add them back one at a time until you find the one(s) that don't play.

yer i will but not this weekend LOL

[restless@westnet.com.au]

hi joe
just did a log of the trans arond town
does the TTC only come on with very little throttle
what sort of presure limit is normal ?

[joecar]

Yes, the TCC is applied at low throttle when vehicle speed is relatively low... check the TCC apply/release tables.

[restless@westnet.com.au]

hi Joe
OK ill check it out
can you tell me witch table to look at to stop it kicking down from 6Th to 3 rd at WOT (very annoying and dangerous and not good for the box when over taking on the highway with 1000 + NM TRQENG )
is it WOT > SHIFT SPEEDS ?
i just don't see a parameter saying 6>3 only 4>3 etc
so do you have to work your way down from 6th to 3 third
thanks bob

[joecar]

Hey Bob,

I'm not sure about the 6L80/90... I'll have to take a look at the tables... you might have to edit the shift tables to maintain a gear longer (vs easily downshifting).


Edit: name corrected.