truck wont start, controller in an unknown state.

[sprouse99]

i was falshing my lb7, and the ethernet cord came unplugged from flashscan tool . started over, seemed to flash fine, but wouldnt start. Having read the warning that pops up, i tried flashing with 7.5, but itr says controller in an unknown state. when i try flashing w/8 it says security access denied. What to do?

[anarchydiesel]

Your ECM is likely a very expensive paperweight now.

[sprouse99]

Your ECM is likely a very expensive paperweight now.

Very expensive since it is a brand new ECM.

[anarchydiesel]

Have you tried disconnecting the batteries to fully power down the ecm?

[sprouse99]

I pulled the ECM fuse, is that the same as? It didnt work, so I put my old ECMback in so i can drive it...the old ECM has forgotten its unlock code, and I cant pull a read or a flash off of it, but it works

[killerbee]

Send the dead one to us. We can restore it if it is still viable.

[Blacky]

Use the V8 flash option and check the two boxes:
"Try Alt Keys" and "Assume lock is faulty"

Regards
Paul