2011 gmc 2500 hd bootloader rejected ?

[JST]

Anything look bad

[joecar]

You are not done yet...

the first step was to get 2.4.72 into your V2...

did you read this document yet: Upgrading Flashscan


V8 will not work until your V2 has 2.7.35... but you must read that document carefully/entirely in order to get there...


[ basically, you want to do Step A and Step D... but reading the whole document explains some things (like dead poll mode, for example) ]

[JST]

Need to send my v2 in,what is the address and what is the cost and how long,I have 100.00 in to this so far with no help (2 computer repair stores),I have 2 trucks to tune with E 78 ECU'S

[Blacky]

Need to send my v2 in,what is the address and what is the cost and how long,I have 100.00 in to this so far with no help (2 computer repair stores),I have 2 trucks to tune with E 78 ECU'S

https://www.efilive.com/index.php?op...d=49&Itemid=84

Regards
Paul

[GMPX]

Need to send my v2 in,what is the address and what is the cost and how long,I have 100.00 in to this so far with no help (2 computer repair stores),I have 2 trucks to tune with E 78 ECU'S

First thing, your posts are not clear and are very hard to read, I can't follow what you are trying to say. "I have 100.00 in to this so far with no help", 100.00 what? dollars, hours?
Next thing, "No help", really?, we are on the 5th page of trying to 'help'.
2 weeks ago Joecar asked you to read the document "Upgrading Flashscan", have you? Why do you want to send the V2 in to EFILive, is it dead?

[JST]

I got it Firmware 2.07.35 bootblock 2.07.04 THANK YOU ALL for the help

[joecar]

I got it Firmware 2.07.35 bootblock 2.07.04 THANK YOU ALL for the help

Ok good



but you are still not quite done yet...



see here (from Insert an SD card onward): Setting-up-a-FSV2-from-scratch

[JST]

I hope it is done,all is working good ?

[joecar]

If you didn't copy the BBx config files, then you're not done yet.

[JST]

I dont know but the truck is tuned and is working good