any workarounds? besides going back to w7 or xp.
I can't full flash with W8
any workarounds? besides going back to w7 or xp.
"All that is needed for the triumph of evil is that good men do nothing..."
I flashed with W8 no problem using V8, when opening the V7.5 Tune Tool I only get half of the status bar (loading calibrations bar). I didnt try flashing with V7.5 and Ive only flashed a T43 a few times with W8 and V8.
Have you tried running the Scan and Tune tools in compatibility mode for W7?
~Erik~
2013 Sonic RS Manual - 1.4L I4T E78, tuned, turbo mods, etc.
2008 TrailBlazer SS 3SS AWD Summit White - LS2 E67/T42, bolt ons, suspension, etc.
2002 Chevy TrailBlazer LT 4X4 Summit White - 4.2L I6 P10, lifted, wheels, etc.
What are you flashing from (V7, V8, V2)...?
Both v7 and v8 cable is v2
Yes I have tried all the possible combinations of compatibility modes etc even doing the install itself in compatibility
I have no issues with cal flash though
The program tries to flash and after sending bootloader ot automatically says completed
"All that is needed for the triumph of evil is that good men do nothing..."
With serial wideband...?
Serial wodeband?
"All that is needed for the triumph of evil is that good men do nothing..."
Is your wideband connected to your V2 using serial comms or analog voltage...?
Yes and No... both ways.. connected or disconnected... it will jump to the just finished without going through the prep steps.
"All that is needed for the triumph of evil is that good men do nothing..."
I'm sure that is the old 'non admin' problem, try running EFILive with admin rights (not sure how you do that on Windows 8), but Win 7 was just right click on the icon and choose Run as Admin.
I no longer monitor the forum, please either post your question or create a support ticket.
Posting Permissions
Reply With Quote