CALC.PIDs

[joecar]

Set B3609 to zeros.

B3616 is set to enable PE at 35% all across... do you want it to enable so easily below 3000 rpm...?

B5913 and B5914 are identical, nulls out knock retard feature, are you sure you want this...?

[joecar]

Thanks wolfie. I Typed a 5 minute response to your post. Looks like the higher ups keep deleting it. Joecar?? come on man.

I didn't delete anything...!?


( I don't see any posts being deleted from here )

[joecar]

Here is my last log I put COS5 in so I can do some boost logs for CALC.VET. This is the last log I have not loadedit yet does it look right.

The Cal I put in it.

Have you created the SELBEN B5001 map and the VET B0101 map and applied them...?

[slows10]

I didn't delete anything...!?


( I don't see any posts being deleted from here )

Ok no problem just seemed strange.

[slows10]

I didn't delete anything...!?


( I don't see any posts being deleted from here )

Ah it wasnt worth any one reading anyway I guess.

[Blacky]

Ok no problem just seemed strange.

I've deleted a couple of spam posts in this thread - but they were in Vietnamese - you weren't replying in Vietnamese were you?

Regards
Paul

[COONDOG96]

Yes I did that before I went to COS5 and got them close before I started getting into boost.

[COONDOG96]

What would be a good safe starting point on B3616?

[joecar]

What would be a good safe starting point on B3616?

For boost, something like 1.25 EQ... if your MAF/VE are correct.

[COONDOG96]

Is there a way to get the engine CC to be remimbered and not have to enter it for every log. I've done logs and forgot to put it in and all you get is zeros.