How do I use the auto tune feature?

[joecar]

ok i have followed the calc.vet pdf and created all the pids, maps and made a few mods to my tune like it suggested at the bottom of the pdf (change from 4000r to 400, chane a few temps in the dfco, etc), uploaded and am ready to log. But the pdf said 'have a friend monitor the maps as they fill in'. I can't get the maps that i made to show up while logging or monitoring.

How do i monitor these? Or am i missing something?

ignore the pdf

[joecar]

Ok, I got the maps to show up. went for a drive and built a new table. I applied the filters and hit 'average' and they all turned to 0.000. Also, about half of the 'selben' values filled in with all 1.0 when i averaged them.

did I miss a step?

I did some reading and it said to set engine displacement. I did this and they are still zero. Again, I am just trying the 'narrow band' tune that is mentioned at the bottom of the PDF.

Post a screenshot of the map

( if you're using % VE units then you need to enter the engine displacement )

( you may need to increase the precision/digits )


PLEASE IGNORE THE PDF... instead please use post #1 of Calc.VET thread.

[bubba68ss]

Please excuse my stupid questions. I'm really trying to get a handle on this.

Here is the screenshot after dropping all values below 10

[bubba68ss]

here is my tune, log, map, PID that I have.

CalcVET_test.zip

[joecar]

Please excuse my stupid questions. I'm really trying to get a handle on this.

Here is the screenshot after dropping all values below 10

No worries, they're not stupid, we're just trying to get to the bottom of things...

in that map, the n button is clicked (shows cell hit counts), click the button x-bar (i.e. x with bar over it)(shows cell average values).

[joecar]

here is my tune, log, map, PID that I have.

CalcVET_test.zip

I look thru your files later tonite, early tomorrow.

[joecar]

Ok I have followed the calc.vet PDF and created all the pids, maps and made a few mods to my tune like it suggested at the bottom of the PDF (change from 4000r to 400, chane a few temps in the dfco, etc), uploaded and am ready to log. But the PDF said 'have a friend monitor the maps as they fill in'. I can't get the maps that I made to show up while logging or monitoring.

How do I monitor these? Or am i missing something?

By yourself you can't really monitor these while you're driving...

in the V7 scantool you can have the map open while you're logging, and a passenger can monitor which cells are hit and which are not...

but since you're using V2 BBL you can't view the map (laptop not in car).

[joecar]

You're using g*K/kPa units so you can ignore engine displacement.

[joecar]

After you click the x-bar button, make sure you also apply the filter, post a screenshot of the filter properties.

[bubba68ss]

No worries, they're not stupid, we're just trying to get to the bottom of things...

in that map, the n button is clicked (shows cell hit counts), click the button x-bar (i.e. x with bar over it)(shows cell average values).

When I do that all the cells turn yellow and show 0.0000