Results 1 to 7 of 7

Thread: Wrong ect in tables but correct in scanner and gauge???

  1. #1
    New Member
    Join Date
    Jul 2010
    Posts
    6

    Default Wrong ect in tables but correct in scanner and gauge???

    I made this post last week about ignition advance http://forum.efilive.com/showthread....ird-low-timing

    I found the problem but not the cause all of the ECT tables are pulling from the 140c value even though scanner and gauge are showing 100c mainly b5910 and b5913

    it also looks like the IAT values are incorrect pulling from the 35c values when scanner shows 1c which would be correct based off temp in dyno room day of log.
    I am using the link feature to find these values. The math checks out that my timing is based off of the incorrect temp.

    If anyone can help I would really appreciate it.

    Thank you, Dale

  2. #2
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Hi Dale,

    interesting...

    post some screenshots.

  3. #3
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    I see the same values in the scantool charts/gauges as the tunetool axis...


    check that the scantool Data tab shows the same units as the tunetool table axes;

    post some screenshots.

  4. #4
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Also, what V7 software build version are you using...?

  5. #5
    New Member
    Join Date
    Jul 2010
    Posts
    6

    Default

    Thanks Joe, I got the scanner straightened out ect and iat were set to f in the data tab. but still cant figure out the timing. going to log some other timing pids now. I really cant see where the advance reduction could be coming from?

  6. #6
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Timing is hard because there are so many tables... and some of them may have not been discovered/reverse-engineered as of yet.

  7. #7
    New Member
    Join Date
    Apr 2011
    Posts
    1

    Default Re: Wrong ect in tables but correct in scanner and gauge???

    Quote Originally Posted by joecar View Post
    Timing is hard because there are so many tables... and some of them may have not been discovered/reverse-engineered as of yet.
    This

Similar Threads

  1. Correct IFR tables for LS3/LS7 injectors in Gen III
    By SweetS10V8 in forum Gen III V8 Specific
    Replies: 157
    Last Post: August 13th, 2018, 06:27 AM
  2. Replies: 2
    Last Post: January 20th, 2012, 01:35 AM
  3. correct me if i'm wrong...
    By SPRAYED07 in forum General (Petrol, Gas, Ethanol)
    Replies: 10
    Last Post: July 27th, 2007, 10:59 AM
  4. ECT Boost tables inop
    By killerbee in forum Duramax LLY
    Replies: 3
    Last Post: February 17th, 2007, 12:24 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •