paste LTFT log file to VE table

[rumblebox]

after months of battling with my LC-1 i finally ripped it out and said fuck it.

now i'm just doing as well as i can by tuning with fuel trims.

i can't figure out how to copy my LTFT log MAP onto my VE table as a percentage. i dont know how a red cell with 300 counts translates to correction on the VE table.

[joecar]

Make a map of LTFTBEN x MAP x RPM (i.e. to match VE table; in map's row and col tabs do Paste Labels from VE table)...

then paste-with-multiply into the VE table.

If you're looking at cell counts, why don't you click the x-bar button (x with bar over it, i.e. average value of each cell)...?

Post screensots.

[rumblebox]

Thanks. Found it. After 1 log/tune, it runs drastically better... as expected.

[joecar]

ok, cool

[rumblebox]

For PE's I'll just use the wideband on the dyno..... Or just let patrick do it lol

[joecar]

I thought you got your LC-1 serial comms going...?


If you're going to get tuned by Patrick, it might be easier to let him do it.