The latest EFILive software is now available as Release Candidate 4 for all EFILive customers.
EFILive encourages customers to use this release in their production environments.
This release is scheduled to become the official public release.
Download here:
Updates since RC3:
- Fixed E55 cal-flashing mis-matched operating system.
- Fixed E39 cal-flashing of *.coz files fails with "incorrect checksum" due to badly formatted *.coz file.
- Fixed pass-thru data logging failure when less than 24 channels are selected and external A/D PIDs are selected and voltage applied to AD1 thru AD4.
- Fixed "g-force units not defined" error.
- Fixed metric/custom scaling issues when using slider to test custom PID units for BBL PID selections.
Firmware
- Since RC3, the FlashScan and AutoCal firmware version number has been updated to V2.07.37. That means once you upgrade the firmware you cannot revert back to V2.07.35 or 2.07.36.
- The firmware version number upgrade from 35 to 36 was required because of the seriousness of the "SD Card surprise removal" bug that was fixed in RC2.
- The firmware version number upgrade from 36 to 37 was required due to external data logging interface updates.
What is not included in this release:
- The Cummins switchable tune (CSP5) feature is not included in RC4.
- The DPF/EGR restrictions for US based customers are not part of RC4.
- Pass-thru logging using the V8 software is not included in RC4 (use V7.5 for pass-thru logging duties).
- Tune file editing using the V8 software is not included in RC4 (use V7.5 for tune file editing duties).
Bug Fixes:
Bugs that have been reported over the past 6 months have been fixed in this release. If you have reported a bug but discover that it has not been fixed or has only been partially fixed in this update, please report the bug again in this thread.
Known Issues:
Please post issues, questions, clarifications (large or small) in this thread.
As issues are reported and confirmed they will be re-posted as "Known Issues" below.
- The RPM24x PID does not display correctly on FlashScan/AutoCal during BBL nor does it display correctly on the V8 Scan Tool charts. It does display correctly on in the V7 Scan Tool. (fixed in RC5)
- When searching for PIDs in the V8 BBL or Scan Tool setup windows, the PID groups are now automatically expanded to show all PIDs that were found. (fixed in RC5)
- Setting the "Auto" check-box for BBL configurations is not remembered. (fixed in RC5)
- Changed BBL alarm alert time setting to correctly show time is 10x ms. (fixed in RC5)
- Disabled BBL alarm hold time setting because it is not implemented on FlashScan/AutoCal for BBL yet. (fixed in RC5)
Regards
The EFILive Development Team