EFILive RC 4 (April 10, 2013)

[Blacky]

The Unlink option for Autocals doesn't seem to work.

What is the error message? Or what happens to indicate that it doesn't work?

You must have the latest firmware in FlashScan and AutoCal.
The unlink process only works if you have the FlashScan device connected to your PC that was used when the AutoCal was originally linked - which means on ly the original tuner who linked the AutoCal in the first place can un-link it.

Regards
Paul

[dansdieselp]

This is what comes up. Trying to unlink the Autocal from my GM V2 to my Cummins V2 for a customer that sold his Duramax and Bought a 07 5.9. Both the Autocal and V2 have the latest firmware from RC4.

[ScarabEpic22]

That is funny I wasn't aware of that, I am sure if you read back far enough you will see them telling customers that those torque coeffs are a waste of time

Oh I have, then after another member (and me later) posted up that he doesnt have to scale his trans tune they added them.

They are definitely NOT a waste of time, you can control almost TOO much of the ECM's behavior to the TCM with them! *Almost*, if you use them correctly they're gold.

On the AC unlink, I should have some free time tomorrow and Ill try it on an AC I have here.

[Highlander]

Nevermind... I was reading too much into the Torque Coef Tables... LOL


Thanks

[Blacky]

This is what comes up. Trying to unlink the Autocal from my GM V2 to my Cummins V2 for a customer that sold his Duramax and Bought a 07 5.9. Both the Autocal and V2 have the latest firmware from RC4.

The error "unknown command action" means the PC based software has sent a command to the device that is not implemented in the device's firmware. Almost certainly because the device's firmwar eis not actually up to date.
What firmware versions do you see on the [F2: USB] tab page of the Control Panel?

Arrgghh - I mean What firmware versions do you see on the [F6: Firmware] tab page of the Control Panel?

Regards
Paul

[dansdieselp]

2.07.36 on Autocal
2.07.36 on Flashscan

[Blacky]

2.07.36 on Autocal
2.07.36 on Flashscan

RC4 installs with firmware V2.07.37, can you check the folder:

\Program Files\EFILive\V8\Firmware
or
\Program Files (x86)\EFILive\V8\Firmware

and see if you have firmware files ending with .37?

Regards
Paul

[dansdieselp]

It shows 2.07.36 It looks like I'm still on RC3. Could of swore I had installed RC4, but that may have been on a customers laptop. I'll install RC4 and try it out.

[Highlander]

The tune tool... is one real nice piece of editing software... i freaking like it............

[ScarabEpic22]

I know this wont even be on the drawing board for V7, but for V8 would it be possible to include DTC text in searches? If you enter say "evap" into the search bar in V7.5, if will show you the EVAP system test and any other mention of "evap", except in the DTC/MIL list. Having this list be searchable in V8 would be very helpful when checking to see if all DTCs with a phrase such as "evap" have been set correctly.