Thinking about it, it would be better if B9021 was predefined rather than 3rd-party cax-defined
Thinking about it, it would be better if B9021 was predefined rather than 3rd-party cax-defined
Hey Joe, so I was just looking over my 02020005.cax file and noticed that the addresses for B9014 and B9021 are the same, (B632). Also my cal_link link file does not have B9013 and B9021. What does the cal link file do?
Here is what I have:
{B9001} Stomp Make Up Fuel
{B9002} Impact Factor Modifier
{B9004} Boiling Time Modifier
{B9005} Wall Mass Factor
{B9008} DFCO Stomp Compensation TPS Min
{B9009} Stomp Compensation Delta Low Limit
{B9010} Stomp Compensation Delta Limit
{B9013} Stomp Compensation Delay
{B9014} Minimum Stomp Fuel
{B9100} Lean Cruise Enable
Here is the cax I was using and B9021 worked ok.
http://forum.efilive.com/showthread....-updates/page2
When I had B9021, it would be located just below B4006 under fuel/injectors/parameters. I have attached my .cax and cal_link files in the first post. Please let me know if you see something obvious. I will try just the .cax b (just B9021) that Mick posted and report back.
UPDATE:
Loaded cax b and B9021 is working now but don't have the others.
Last edited by O1Z06; May 28th, 2013 at 05:03 AM.
2001 Z06 512K Road Runner COS5
LSx 427, Comp 7075 TT in progress