I thought there was a beta version floating around. and they were very close to completing the finial version.
We are close to pulling season and I would like to set up the 3rd gear start
Any one have an A40 tcm for sale?
Thanks, Rick Abare
I thought there was a beta version floating around. and they were very close to completing the finial version.
We are close to pulling season and I would like to set up the 3rd gear start
Any one have an A40 tcm for sale?
Thanks, Rick Abare
We'll do it for $450.
Little consolation maybe, but it's an option. http://duramaxtuner.com/tcm
Nick
I no longer monitor the forum, please either post your question or create a support ticket.
Don't get too excited Rick!, we were just looking to add basically what the A40 has for tables. We have A50 TCM's here, thanks for the offer.
I no longer monitor the forum, please either post your question or create a support ticket.
I have my first pull Sunday and I will most likely just run High range 1st gear until I figure out what to do. I just installed the Fleece 63mm cheata turbo with Danville tuning, egr deleat, transgo, vigilante converter. When I did the trany relearn I blew right through 5th gear and limped the trany. I tried again 2 days later and a full power shift into 5th limped the trany again so I need to stay away from over drive. I haven't built the trany yet so I want to stay away from any shifting while pulling and I should be ok. the best thing about low range 3rd is the tuning will lock the converter were it woun't in high 1st
Rick
I want to tune it so any time I shift into 4low it will go to 3rd gear start. A lot of the guys have to switch their tcms at the track then switch them back when they are done. It is very rare I use 4low other than pulling so I thought it would be nice not to have to switch them.
Does your price of $450 include any tuning or do I still need to go get it flashed at a gm dealer.
Rick
Yes, but it's not on top of the list of "to do's" at the moment. Sounds like if you need the trans sorted ASAP then Nicks solution might be the way to go.
I no longer monitor the forum, please either post your question or create a support ticket.