Results 1 to 4 of 4

Thread: Would faulty BCM causing PCM not detected

  1. #1
    Senior Member auspeed's Avatar
    Join Date
    Jul 2010
    Posts
    102

    Default Would faulty BCM causing PCM not detected

    I can read the PCM fine on the bench harness, & the vats is/was disabled in the tune. The car (holden vy clubsport) fires then dies as like it needs a VATS relearn done. However
    when connected in the car efi live can't detect the pcm, can't read/write or change vin etc......

    Suspected the BCM maybe faulty but would that cause the pcm comms to be affected?

  2. #2
    Lifetime Member
    Join Date
    May 2010
    Posts
    507

    Default

    Start pullin fuses and try to flash until you pick the right fuse. Then it will probably detect and flash your ecm.
    1997 S10, 06 trailblazer SS LS2 swap, 4L70E trans, 76mm turbo. Factory ZQ8 suspension. 3.08, G80 w/a zexel. With a 0411 swap.

  3. #3
    Lifetime Member GMPX's Avatar
    Join Date
    Apr 2003
    Posts
    13,148

    Default

    On the LS1 Holdens there was no other modules on the PCM's comms bus so it's pretty clean (unlike many US vehicles). I doubt the PCM is faulty, I suspect it's be some silly alarm system that cuts power to the PCM.
    I no longer monitor the forum, please either post your question or create a support ticket.

  4. #4
    Senior Member auspeed's Avatar
    Join Date
    Jul 2010
    Posts
    102

    Default

    Well the car starts then stalls, and can't connect to PCM, I suspect its the BCM module.

Similar Threads

  1. Replies: 14
    Last Post: June 5th, 2013, 03:09 PM
  2. PCM and BCM Swap possibility???
    By goldbergv95 in forum LL8 4.2L In-Line 6 - P10 PCM
    Replies: 28
    Last Post: February 7th, 2013, 02:31 AM
  3. Pcm not detected??
    By Meister in forum IL6,IL5,IL4 Atlas Engines - P12 PCM
    Replies: 6
    Last Post: December 14th, 2011, 11:51 AM
  4. pcm noy detected on scan only wtf?
    By z28ls1818 in forum FlashScan V1
    Replies: 3
    Last Post: December 15th, 2009, 03:32 AM
  5. ECM, TCM, PCM & BCM Issues Who's the Expert
    By MN C5 in forum General (Petrol, Gas, Ethanol)
    Replies: 3
    Last Post: December 7th, 2008, 12:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •