Looking to figure out how I can use my Autocal to scan ABS Codes. Is it possible or only engine and tranny codes?
Looking to figure out how I can use my Autocal to scan ABS Codes. Is it possible or only engine and tranny codes?
2006 Chevy Silverado 2500HD LBZ Allison 10005" Magnaflow Turbo Back w/ K&N IntakeCognito 4" NTBD on 33" BFG's w/ H2'sEFI Live Autocal with custom IdahoRob TuningModerately Modified
2006 Chevy Silverado 2500HD LBZ Allison 10005" Magnaflow Turbo Back w/ K&N IntakeCognito 4" NTBD on 33" BFG's w/ H2'sEFI Live Autocal with custom IdahoRob TuningModerately Modified
On my flash scan v2 i just plug it in to the obd2 port and not the computer turn the key to the on position(YOUR AUTOCAL SHOULD BE THE SAME IM ASSUMING). Then go into diagnostics on the device, then go to trouble codes, display DTCs, and then go down to MFG ALL DTCs. That should give you any code the truck is throwing. Let me know if this works
When I hook up the Autocal to the OBD2 port I can either full flash or program any of the tunes or log data and check live PID's but when I go to check DTC's it scans but last week when my ABS light was on due to a bent hub on the LH Front(apparently) it wouldn't read the ABS code. It just said no codes stored or whatever. I didn't see any option on my Autocal for MFG ALL DTC's. Do you scroll down before checking for DTC's then or where is that option does it have to be set up first somhow?
2006 Chevy Silverado 2500HD LBZ Allison 10005" Magnaflow Turbo Back w/ K&N IntakeCognito 4" NTBD on 33" BFG's w/ H2'sEFI Live Autocal with custom IdahoRob TuningModerately Modified
ABS code would be MFG code... you should be able to scroll down.
I tried again. Could not see anything that said MFG Codes or anything like that. Then I checked my email and got this reply from EFI...
"The Scan Tool functionality built into AutoCal will currently only read trouble codes from the following CAN modules:
ECM Engine Control Module
TCM Transmission Control Module
FSCM Fuel System Control Module
TCCM Transfer Case Control Module
GPCM Glow Plug Control Module
We intend to add the ability to read trouble codes from other CAN modules (including the ABS module) in a future update.
Regards
Paul"
So I assume the Autocal wont read ABS codes then. Is it just guys with the V2 saying you can or has anyone read them with their Autocal?
2006 Chevy Silverado 2500HD LBZ Allison 10005" Magnaflow Turbo Back w/ K&N IntakeCognito 4" NTBD on 33" BFG's w/ H2'sEFI Live Autocal with custom IdahoRob TuningModerately Modified
I tried V2 to read ABS codes without luck
I think even V2 can't read ABS codes
EFILive Tuner
Getting the DTC's from the modules isn't the major hurdle, it's the 1,000 or so DTC descriptions that needs to accompany all the codes for all the modules, ABS, BCM etc. We have traditionally taken the stance that we will support diagnostics on modules we can tune.
I no longer monitor the forum, please either post your question or create a support ticket.