Has anyone been able to do switching with an autocal yet? Or is this just for v2's right now? The tutorial says that it works for both. I cannot seem to find any other info on this.
Has anyone been able to do switching with an autocal yet? Or is this just for v2's right now? The tutorial says that it works for both. I cannot seem to find any other info on this.
Depends what firmware you are sitting at right now. If you have V2.07.49 on your autocal, you have to wait for the update that is suppose to happen any day now (had conflicts on firmware). Unless cindy says different. If you have older keep it for now but you need to read the Cummins ECM 5.9L CSP5 User Guide under the help/documents section of the V8 software. Basically need to setup logging config to enable switching. Hope that helps.
Jon
Subd
2015 3500HD crew cab long bed, 6" fabtech, slightly tuned, emissions intact.
2005 dmax ccsb, EFI live tuned DSP 5 Full built motor, S471 billet single, More better built trans this time. and lots of other things.
1984 CJ7 powered by a 2000 LS1. 4L60E.
2012 Jetta TDI 6 speed manual, (yes the dirty the bastard haha)
2003 Jetta TDI,
1986 K10 LQ4/4L80E
CSP works with both FlashScan V2 and AutoCal. Customers will need to wait for our next software release to use these features.Originally Posted by blklmm
All customers using historical CSP software WILL BE REQUIRED TO UPGRADE to maintain compatibility.
Cheers
Cindy
Guess you'll have to WAIT like the rest of us.
So currently the only way to switch csp is with a v2 or a socal switch (that will need to be updated at the next software release)?
Currently there is no way to switch.
The July 18 release that did have CSP was withdrawn (ie can no longer be downloaded). The August 25 release updated firmware to make July 18 inoperable. Our beta test group has access to beta software and this is the only software that currently supports switchable tuning.
A public pre-release is scheduled for release in the next day or so. When customers update to that release they will have access to switching via FlashScan V2 and AutoCal. Customers can also purchase third party approved products for switching. SoCal diesel is currently shipping their switches in anticipation of our release. The Starlite Diesel app is not quite ready for purchase yet.
Cheers
Cindy
CSP software is now available for download. You can read what it includes here http://www.efilive.com/latest/cat/ne...5-pre-release/
Cheers
Cindy
thank you cindy
Posting Permissions
Reply With Quote