CSP5 and EDA Release for 06-07 Cummins

[KhakiCummins]

Is BBL added for all supported Cummins or is it just for the 06-07 Cummins at this time?

[2007 5.9]

BBL is ONLY avail when running csp.

[WyoFreeride]

Where does the CSP5 switch plug into? Does it have an OBDII plug and remain plugged in there to allow switching between tunes?
I ask because I am running EFI, buthave an Edge Juice that I use for gauges. The Edge must be plugged in in order to read a couple of the parameters. I have a feeling that I will only be able to use one or the other, and not both.

If you have an Insight monitor and when Edge releases the update to allow CSP5 tune switching, you will be able to use that. If you have an Edge tuner (the Original Juice with Attitude, Evolution, Etc) then you will not be able to switch tunes with that hardware.

The SoCal Diesel CSP5 switch connects to the OBDII port, you can also use the other switching solutions noted above, or use your V2 or Autocal.

Once you switch tunes, you could disconnect whatever device you used to switch with, and the tune selected will remain selected.

(As far as I know on all this, I'm sure someone will correct me if I was incorrect anywhere)

[2007 5.9]

No edge implementation anytime soon...looks like my insight may be a paperweight!!!

[catman3126]

Subd

[cindy@efilive]

Timing calculator will be added back for our next release.

Cheers
Cindy

[WyoFreeride]

No edge implementation anytime soon...looks like my insight may be a paperweight!!!

No good, I was thinking about one for a couple people interested, The DashDaq might be the ticket instead, assuming it gets the CSP option sooner than later.

[2007 5.9]

Called Drew Tech this morning and the cust svc guy had no clue what I was talking about.

[GMPX]

To be fair to Drew Tech, we've only been dealing with the guys in the Tech department, what they are working on may not have flowed through to the customer service people.
Timing calc will be in the next update (to cover all CSP tables).
There is no need to leave a switching device in the truck (such as a V2), the tune is never forgotten once selected, even if you disconnect the battery! The only time the tune changes from what you last selected is if you reflash the truck, unfortunately that is just what the ECM does after it reinitialises itself after a reflash.

[Motorzane]

I get a "Error: $0194: Write failure." When I try to program the Black V2. It goes through fine on the Blue V2