Has anyone had problems data logging with CSP5? I can use EDA using bbl and I can change tunes.
Has anyone had problems data logging with CSP5? I can use EDA using bbl and I can change tunes.
What's the problem?
BBl sounds like it works...
Sent from my iPhone using Tapatalk 2
Les Szmidt
2007 5.9 Dodge Ram
2014 Ram 3500 Aisin tuning Emissions Equipped
EFI Live Cummins BETA Tester
Silver Bullet Tuning
silverbullettuning@gmail.com
www.youtube.com/ljszmidt
http://www.facebook.com/SilverBulletTuninig
I cant look at live date using v7.5 or v8. Using scan 7.5 it wont let me select the EDA pid group.
Just make sure you've followed the guide to select the EDA PID group, and at what point does the scan tool perform functions not as described in the document?
Live scanning should be functional in V7.5 however this function is not available in V8.
Cheers
Cindy
I no longer monitor the forum, please either post your question or create a support ticket.
Cindy,
I can verify scan tool operation in pass-thru this afternoon after work, I'll post my results.
Sent from my iPhone using Tapatalk 2
Les Szmidt
2007 5.9 Dodge Ram
2014 Ram 3500 Aisin tuning Emissions Equipped
EFI Live Cummins BETA Tester
Silver Bullet Tuning
silverbullettuning@gmail.com
www.youtube.com/ljszmidt
http://www.facebook.com/SilverBulletTuninig
Thanks Les,.
Cheers
Cindy
I no longer monitor the forum, please either post your question or create a support ticket.
My truck has Csp5 installed and I use v2 to switch tunes that works and I have verified that. In v8 I checked the box to reload previous pid group the named my tunes selected CMB pid list per the guide clicked and drug the pid sub folder EDA1 to the box on the left per the guide and selected program all. initially got a "write failure" error code but after formatting it programmed all. Then it would switch tunes and everything but the only time I can select the EDA Pid group in v7 scan tool is if I uncheck the box for supported then I can select EDA but all pids are invalid. This is with v2 connected to truck with csp5 and laptop before starting v7. I did load the tune in the truck befor configuring v2 for eda and haven't flashed since
With setting up V7.5 are you absolutely 100% sure you are following the user guide exactly as shown under "Data Logging with V7.5 Scan Tool", page 15?
In V7.5 scan you might also try to force PID revalidation when connected to the truck (press Shift + F2).
I no longer monitor the forum, please either post your question or create a support ticket.