CSP5 DATA LOGgING INOP

[cumminsDK]

Awesome PID selection! I see some long desired parameters!

[2007 5.9]

Yes i just tested it and "Validate PIDs" is MANDATORY!!!

Other than that it's perfect


Sent from my iPhone using Tapatalk 2

[GMPX]

I clicked on the validate pids icon and bingo it worked otherwise would not allow me to select. I guess I was just spoiled with the software always doing it for me!

Just make sure the EDA PID's are still the only group selected or it will slow the logging rate down considerably as it drops back to factory mode.

[cumminsDK]

Right! Should rarely need a pid not included in EDA!

[jordylee18]

Right! Should rarely need a pid not included in EDA!

External thermocouple pids are nifty!

I wish one of the two available was included in EDA.

[cumminsDK]

Those are handy but my test trucks have them and not feasible in customer rigs most if the time would definitely be a plus for competition set ups

[garrettg.bpd]

Validating PIDs did the trick. If I switch tunes 2 or 3 times when data logging the V2 will stop working. I have to unplug it for the pc and then it will start working again. Is this normal?

[2007 5.9]

Validating PIDs did the trick. If I switch tunes 2 or 3 times when data logging the V2 will stop working. I have to unplug it for the pc and then it will start working again. Is this normal?

Are you bbl with v2 plugged into computer at the same time?


Sent from my iPhone using Tapatalk 2

[cumminsDK]

One issue I have had I named the tunes in v8 and programmed v2 names were correct then somewhere in the haste of trying to get EDA to work in v7 the names changed. All names in incremented up one spot, 1 moved to 2, and 2 to 3 and so on. The name for five is gone and tune 1 is named just that "tune #1" on the v2. The names are still correct in v8. I have erased and renamed in v8 and reprogrammed but they remain the same. Small issue and names aren't real critical but an issue none the less.

[2007 5.9]

One issue I have had I named the tunes in v8 and programmed v2 names were correct then somewhere in the haste of trying to get EDA to work in v7 the names changed. All names in incremented up one spot, 1 moved to 2, and 2 to 3 and so on. The name for five is gone and tune 1 is named just that "tune #1" on the v2. The names are still correct in v8. I have erased and renamed in v8 and reprogrammed but they remain the same. Small issue and names aren't real critical but an issue none the less.

They changed in the v2?

I'm not quite following...


Sent from my iPhone using Tapatalk 2