GM.BOOST_DMA not available as a BBL PID for E60 controller?

[thunder550]

I'm trying to get my V2 set up to BBL with the same PID selection I use when logging with my laptop. I noticed that GM.BOOST is available, but GM.BOOST_DMA is not. I would just switch, but GM.BOOST_DMA is needed to "activate" CALC.ACTBOOST (Actual Boost Pressure) so I can see that one as well. Am I missing something?

As a side note, is there a way to select CALC PIDS for BBL, or do I just need to select them once I open the log file in the scan tool?

[joecar]

You can make a calc pid to calculate boost as "{SAE.MAP.kPa} - {GM.BARO.kPa}" or "{SAE.MAP.psi} - {GM.BARO.psi}" (or similar).

[thunder550]

Done, thanks!

[ACCLR8N]

As a side note, is there a way to select CALC PIDS for BBL, or do I just need to select them once I open the log file in the scan tool?

Hit the "V7" button in V8 where you configure your BBL PID list. You type in the calc pid without the "calc." prefix.

[thunder550]

Hit the "V7" button in V8 where you configure your BBL PID list. You type in the calc pid without the "calc." prefix.

Awesome, thank you!