Last edited by GSXRTURBO1; September 20th, 2013 at 05:50 AM.
Last edited by GSXRTURBO1; September 20th, 2013 at 05:52 AM.
Yes, and No.
If I need to also select and log BARO, then that may be my problem. I just assumed it would know what BARO is and subtract it, but obviously it can't know exactly what BARO is at any given moment unless I'm monitoring (logging) it.
Wait, I'm confused. The PIDS I selected for Datalogging were in V8 in BBX, I don't recall selecting any PIDS in V7 at all.
Are you logging with V7 and a laptop in vehicle, or with V2 in standalone (no laptop)...?
If you log with V2 BBL:
- configure BBL to log SAE.MAP and SAE.BARO,
- program into V2,
- take V2 to vehicle and log,
- take V2 to laptop
- uplod log to PC,
- continue on as in next paragraph:
If you log with V7 scantool/laptop:
- run V7 scantool,
- goto PID tab,
- click on the heading of the last column on the right (to sort by this column),
- locate and select the pid CALC.BOOST,
- save log file (to save the calc pid into the log file),
- goto Dash tab,
- on gauge/chart select the pid CALC.BOOST (in psi),
- you should be able to view the CALC.BOOST data.