Known issues with Nov 07 2013 release of the EFILive software and firmware.
Currently known issues and possible workarounds for the November 07, 2013 release of the EFILive V7.5, V8 software and the V2.07.52 FlashScan and AutoCal firmware.
Issue 1:
The "Created By" and "Modified By" fields in the V8 [F2: Tune]->[F4: Properties]->[File/Author Information] page are "read-only" which means data cannot be entered into them.
Also the "Modified" date field is not being loaded correctly from the file and always shows as Jan 01, 2000. The date is updated and stored correctly in the file, and once the fault is fixed the date will display correctly in all existing files.
Workaround:
You can populate those fields using the name entered into the Properties->General->User Info settings. Whenever you modify and save the file the "Modified By" field is updated with that name, whenever you read a controller and save the file for the first time, the "Created By" field is updated with that name.
Issue 2:
The V8 software does not recognize corrupt serial numbers from LB7 (E54) or LLY (E60) controllers in the same way that the V7 software does. That means EFILive V8 may prevent flashing of controllers with corrupt serial numbers (because it thinks they are not licensed correctly) even though the corrupt serial number is licensed to the FlashScan or AutoCal device.
Workaround:
Use the V7 software to flash controllers with corrupt serial numbers.
Issue 3:
The V8 software fails with an access violation when attempting to change the VIN embedded in a *.ctz file.
Workaround:
None. Will be fixed in the next update.
Issue 4:
Clicking in the chart area in the V8 Scan Tool software does not give focus to the charts if the "Ctrl+F2 mouse disable" option is active.
Workaround:
Press "Ctrl+F2" again to re-enable the mouse prior to clicking in the chart area.
Issue 5:
Paste and Multiply option in the V7 Tuning Tool software incorrectly modifies target cells for which the matching source cells are empty when the weighting value is other than 100%. The target cells should always be left untouched when the source cells are empty.
Workaround:
None. Will be fixed in next update.
Issue 6:
Error number $0525 is being incorrectly reported as error number $0528. Any time the software or firmware reports error $0528, it actually means error $0525
Error numbers and their descriptions may be looked up in the document: Start->All Programs->EFILive->V8->Documents->EFILive Error Codes.
Workaround:
None. Will be fixed in next update.
Issue 7:
The V8 software fails with an access violation when deleting the last "BBL Enabled Controller" entry.
Workaround:
Always leave at least one entry in the "BBL Enabled Controllers" list. Will be fixed in the next update.
Please only use this thread to discuss existing issues that are posted above. This thread is not for posting or discussing new problems with this release of the EFILive software. If you have a problem that is not listed here, please create a support ticket as described here: http://support.efilive.com/kb_articl...7778-QEKN-0400
Regards
Paul
