If you're using WB02 to tune, then they aren't in your PID list.
Since it's via the analogue port you need to log EXT.AD1, then to convert that to raw logged voltage to AFR, you need to log CALC.ARF_PLX1 (PLX uses the same voltage coversion as AEM - 2v+10)
Then, log the CALC.BEN_PLX1 for you correction factor.
Also add DYNCYLAIR_DMA, TPS.
The HO2S11/2 & LONGFT1/2 are unnecessary when WB02 tuning and can free up some more PID channels to keep it under 25, same for IDC2 & INJDC2, 1 bank is ususally adequate.
Don't try to follow the tutorial for VE/MAF tuning, go to the CALC.VET Thread and use this revised procedure.