New to forum -deciding to buy

[joecar]

Use the USB2 port (you can configure the USB3 port to be USB2)... and use the older USB driver (Start->All Programs->EFILive->V8->USB Driver Manager)

[SW1911]

ok , new news , im dropping out on my scanner now , like every 30 seconds on every computer I have 4 of them all configured the same , this is very frustrating , if I unplug it from the usb port it will come back for 30 seconds and the worst part is im right in the middle of a file a very important one , joe thanks but im not sure what driver to use there are three choices ,,,, im on windows 8

thanks guys
Jim

[SW1911]

tried all drives none work correctly

[joecar]

Use driver 2.2.4.

Set your USB ports to 2.0 (not 3.0).

[SW1911]

all of the other computers are and none of them worked ? stumped joe

[joecar]

You're logging with the V7 scantool and after 30 seconds it drops out of logging...?

[joecar]

In scantool, go Edit->Properties->Logging, and set "Frames (x1000)" to 50 or 100 (so the log time goes greater than 1 hour)... click Ok and restart the scantool.

[SW1911]

kool i will try that , i was told the v8 was not ready so i am on v7 thanks joe