I have the Flashscan V2, updated to most recent firmware. I'm trying to set up an egt probe. Yes, it is type K.
When I connect the probe to the bottom of the flash scan, it reads a constant 0*C or 32*F via the "Temp1" PID. It actually reads the exact same whether the probe is connected or not, or whether the probe is grounded (in the manifold) or not (as in holding it in my hand). Do I need to do something with the software to get it to record properly?
I've been told it's the same probe that has been successfully used with EFI Live before, but no one can offer any help on set up.
Thanks for any help.